Minoura Bike Cradle 4 User Manual download pdf (Page 2)

- 4 -

Do not remove the Arm Connecting Screw.

Just loosen.

Each arm is fully angle

adjustable in +/- 35 degrees in

order to fit various types and

sizes of bike frame (see Fig. G).

Do not set both hooks higher than level.

The hook which holds the main load must

be located lower than the clamp body.

Tighten every bolt rmly before loading the

bike. If the arm xing screws have been

loosened, they may come down due to the

bike weight and may drop the bike in the

worst case.

Insert the Pivot-Pin to the clamp from

bottom hole, and screw the Pivot-Pin

Fixing Screw with a washer to hold the

pin (see Fig. D).

You don't have to tighten the bolt

firmly yet.

Rotate the Pivot-Pin to align the thread

hole on the pin and the side hole on

the clamp body, then screw the Clamp

Tightening Screw.

(see Fig. E).

You don't have to tighten the bolt firmly

yet.

After fixing the clamp height

and angle, tighten the Clamp

Tightening Screw first (see Fig. F).

(Tightening Torque: 3 N.m)

After that, tighten the Pivot-Pin

Fixing Screw to secruely hold the

clamp.

(Fig. D)

(Fig. E)

(Fig. F)

(Fig. G)

To change the arm angle, insert an M5 hex

wrench into the center hole on the Cradle Cap

then loosen the Arm Connecting Screw.

(see Fig. H)

(Fig. H)

Loosen the backside screw which holds the arm,

grab the arm and change the arm angle.

After changing the angle, tighten the screw firmly.

(see Fig. I)

(Fig. I)

Contact

MINOURA JAPAN

1197-1 Godo, Anpachi, Gifu 503-2305

Phone +81-584-27-3131 / Fax +81-584-27-7505

[email protected] / www.minoura.jp

Made in Japan

If you need help or have a question, please contact the shop first

where you originally purchased this product.

If you cannot get enough service or answer from them, you can

1 2

Bike Cradle 4 1
MINOURA JAPAN 2

Comments to this Manuals

No comments

Minoura Bike Cradle 4 User Manual Page 2

Comments to this Manuals

Related products and manuals for For bicycles Minoura Bike Cradle 4