Minoura HMS-10 User Manual download pdf (Page 2)

Assembling HMS-10

Required Tool : 17mm spanner

Remove Velcro tape and fully open both d left side legs. (Fig. A

& B)

Be sure the legs must be pulled (the pivot bolt in the long hole is

located near side) when opening.

(Fig. B & C)

Open the lever of the quick release skewer on the leg to open the

clearance at the bottom nut, then push the leg toward the pillar

until the pivot bolt reaches the hole end. (Fig. D)

Close the skewer lever beyond the leg bracket to be locked

securely. (Fig. E)

(Fig. C)

M10 Flat Washer

10mm Nylon Nut

Install the saddle holder and washers to the pillar top.

Tighten the Nylon nut with a 17mm spanner. (Fig. F)

You don't have to fix the saddle holder, it must be able to

rotate slowly when applying bike weight.

But be sure that free rotation could be dangerous because

the bike will not be supported stable.

The bike will be positioned automatically due to the

weight balance that the front tire touches the floor. It is

the standard working position.

The tube pad of the saddle holder must wear.

Replace it when it's damaged. Using with broken pad

should scratch the saddle rail or seat post.

Saddle Holder

Please be advised that it's dangerous

the bike is suported while both front

and rear tires are off from the oor.

It should spoil the weight balance and

fall down easily.

(Fig. D)

(Fig. E)

(Fig. B)

(Fig. A)

(Fig. F)

Leg

Pillar

Quik Release Skewer

Velcro Tape

If the skewer is not securely tightened,

open the lever and turn the nut to

adjust the lever tightness correctly.

1 2

Comments to this Manuals

No comments

Minoura HMS-10 User Manual Page 2

Comments to this Manuals

Related products and manuals for For bicycles Minoura HMS-10