Minoura W-3100 User Manual download pdf (Page 2)

Place the assembled Lower Frame on the floor, and

check if it sits stable as every Adjusting Screw is

touching the floor perfectly.

If not, adjust the length of the Adjusting Screw then

tighten the lock nut firmly by a 13mm spanner.

This is very important to keep enough stability while

your bike is on the stand.

13mm spanner

Assemble the clamp jaw unit to the Upper Pillar.

Put the Clamp Shaft through the hole and hold it with

the Back Knob and a flat washer.

The knob should be tightened as firmly as possible until

the clamp jaws rotates smoothly.

Insert the assembled Upper Pillar into the Lower Frame

until the bottom cut-outs catch the Upper Pillar Holding

Bolt, then tighten the Lock Bolt firmly by a 5mm hex

wrench.

If you don't tighten the Lock Bolt, the Upper Frame will

be removed suddenly when you lift up the W-3100 by

grabing the Upper Frame.

To install the optional Tool Tray, insert the tray into the

Upper Frame

BEFORE

connecting the frames.

Fix the position, then tighten the small knob bolt.

Lock Bolt

Cut-out on Pillar

Upper Pillar Holding Bolt

Tool Tray

Knob Bolt

1 2 3 4

No comments

Minoura W-3100 User Manual Page 2